Turn the connecting rod a quarter turn to unhook it from the door lock cylinder lever, unclip the outer cable from the lock housing and give the inner cable a quarter turn to disconnect it from the door lock linkage. 2013 Sterling Gray Metallic Escape SEL 2.0L 4WD w/Equipment Group 302A, Panorama Roof, Ford OEM Cargo Area Protector, Ford OEM Splash Guards, WeatherTech All-Weather Floor Mats (front only), Ford OEM Center Console Tray, Aluminum Pedal Covers, Fitted LED DRLs.
#2014 ford focus rear door panel removal free#
After ensuring that all the edges are free of cargo compartment stuff along the bottom and the press-on trim around the liftgate opening, it takes a very firm-sharp yank using. Pry out the locking clip for the remote control rod with a flat screwdriver you might need to replace it as it can break. This automotive maintenance tutorial was specifically written to assist owners of the second generation (2013, 2014, 2015, 2016 and probably also the refreshed. I've removed both sides in my '14 multiple times in the process of doing audio / acoustic treatment mods. located under the right hand side of the instrument panel remove the trim panel and. Remove the assembly security shield by unclipping the trim in the back and removing the screws. Look at your passenger side to see what youre up against. If it wont open from either side- you should start searching local junkyards for a correctly colored replacement panel now.
#2014 ford focus rear door panel removal driver#
2011 FORD FOCUS MK3 REAR RIGHT DRIVER SIDE DOOR CARD 5 DOOR HATCHBACK.3.
You will need this work top close to the car door since the assembly is still connected to cables. FORD DOOR CARD PANEL TRIM CLIPS INTERIOR TRANSIT CUSTOM FOCUS FIESTA MONDEO X 10.
Place the lock assembly on a work top so you can easily work with it. Unclip the reinforcement bracket for the lock and handle from the door panel, and you can move the assembly (with the door lock mechanism) out of the door through the inner frame. Remove the three bolts on the rear door edge surrounding the lock assembly-these will require a Torx wrench. With the exterior handle removed, disconnect the electrical connector for the door lock motor-you will need a small screwdriver to release its retaining clip.
0 kommentar(er)
